Sunday, November 15, 2009

What is Inter RAT HO ?

1. Inter RAT HO is network controlled through source access system. The source access system decides about starting the preparation and provides the necessary information to the target system in the format required by the target system. That is, the source system adapts to the target system. The actual handover execution is decided in the source system.

2. Inter RAT HO is backwards handover, i.e. radio resources are prepared in the target 3GPP access system before the UE is commanded by the source 3GPP access system to change to the target 3GPP access system.

3. To enable backwards handover, and while RAN level interfaces are not available, a control interface exists in CN level. In Inter RAT HO involving E-UTRAN access, this interface is between 2G/3G SGSN and corresponding MME/Serving Gateway.

4. The target access system will be responsible for giving exact guidance for the UE on how to make the radio access there (this includes radio resource configuration, target cell system information etc.). This information is given during the handover preparation and should be transported completely transparently through the source access system to the UE.

5. Mechanisms for avoiding or mitigating the loss of user data (i.e. forwarding) can be used until the 3GPP Anchor determines that it can send DL U-plane data directly to the target system.

6. The handover procedure should not require any UE to CN signalling in order for data to start to flow in the target system. This requires that the security context, UE capability context and QoS context is transferred (or translated) within the network between source and target system.

7. Similar handover procedure should apply for handovers of both real time and non-real time services.

8. Similar handover procedure should apply for both Inter RAT Handover and intra-LTE Handover with EPC node change.

9. Network controlled mobility is supported even if no prior UE measurements have been performed on the target cell and/or frequency i.e. “blind HO” is supported.

5 comments:

Anonymous said...

Thanks Vikram :)

That was very helpful!

Anonymous said...

Thanks Vikram :)

That was very helpful!

Vikram said...

Welcome Neil :)

X.R said...

Helpfull content but why does this occur ?
http://wirelesscellularnetwork.blogspot.com/2017/06/wcdma-3G-Inter-Rat-IRAT-Frequency-Handover.html

X.R said...

Helpfull content but why does this occur ?
http://wirelesscellularnetwork.blogspot.com/2017/06/wcdma-3G-Inter-Rat-IRAT-Frequency-Handover.html